Privacy Policy

Cookie Preferences

We use cookies and other tracking technologies to improve your browsing experience on our website, show you personalised content, and analyse our website traffic. Privacy Policy

Privacy Policy
Choose Language:

Panel Connection – Dial Capture

Manufacturer Vanderbilt
Model SPC 4300
Version MCM version greater or equal to V1.06
Minimum Panel Firmware V2.1.0
Cable required? MCM
Panel Profile Vanderbilt-SPC-MCM
Panel Bus Connection None
Technical Notes

See below


Panel Connection Information

DualCom Pro MCM Vanderbilt (PC137421 MCM Unit)
A A
B B

Panel Programming

  • Default Keypad Login code = 1111
  • Login to panel > “Full Engineer” will be displayed > Press “Select” button > “System Status” will
    be displayed
  • Scroll down menu until “Communication” is displayed > Press “Select” button
  • Scroll down menu until “Modems” is displayed and press “Select” button > “Primary” is
    displayed > Press “Select” button
  • “Enable Modem” is displayed > Press “Select” button to set modem to be enabled
  • Scroll down menu until “Country Code” is displayed > Press “Select” button to set to UK
  • Scroll down menu until “Answer Mode” is displayed >Press “Select” button to set to numbered
    rings of 1 ring
  • Scroll down menu until “Line Monitoring” is displayed > Press “Select” button to set mode to
    “Disabled”
  • Press “Back” button until “Primary” is displayed > Scroll down menu until “Backup” is displayed
    > Press “Select” button to disable the backup modem
  • Press the “Back” button until “Modems” is displayed > Scroll down menu until “Central Station”
    is displayed > Press “Select” button
  • “Add” will be displayed > Press “Select” button to create a new “Central Station” account
  • Input account ID > Press “Enter” button. (Press and hold button for number input)
  • Input account name > Press “Enter” button > Select [SIA] as the protocol to use > Press “Select”
    button
  • Input the 1st “Phone Number” > Press “Enter” button > Clear 2nd “Phone Number” and press
    “Enter” button
  • Press ”Back” button until “Central Station” is displayed
  • Scroll down menu until “Remote Maint.” is displayed > Press “Select” button to enable “Remote
    Maintenance”
  • Scroll down menu until “ID” is displayed > Press “Select” button > Input ID
  • Scroll down menu until “Password” is displayed > Press “Select” button > Input password
  • Scroll down menu until “In Conns. Setts” is displayed > Press “Select” button > Disable IP
  • Press back until “Remote Maint” is displayed > Scroll down menu until “SPC Pro” is displayed >
    Press ”Select” button
  • Enable access, and input ID and passwords > Disable IP > Press “Back” until no longer in
    “Engineer Mode” 
© Copyright CSL 2024