Panel Connection – Dial Capture

Manufacturer Hills Reliance
Minimum Panel Firmware 1.00
Cable Required 
Panel Profile HILLS-RELIANCE-MCM
Pannel Connection Dial Capture

Panel Connection Information

DualCom Pro 1 - MCM plug-on module - Line A
DualCom Pro 2 - DI
PSTN A
DualCom Pro 1 - MCM plug-on module - Line B
DualCom Pro 2 - AL
PSTN B

Panel Programming

    To access the panel for configuring, press keypad keys *8 then Installer code.

    • Keypad will display [Enter the device address then #]
    • Then press 0 and # to select the panel.
    • Keypad will display [Enter the feature no., then #]

    Press 4 then # to select Phone Number One.

    • Keypad will display [Feat. 4 Seg# 1].
    • Input the telephone number 0123456789 by pressing one digit and the * for each of the numbers in the telephone number then press #
    • Keypad will display [Enter the feature no., then #]

    Press 5 then # to select System Account Code.

    • Keypad will display [Feat. 5 Seg# 1].
    • Input the account number by pressing one digit and the * for each of the numbers in the account number then press #
    • Keypad will display [Enter the feature no., then #]

    Press 6 then # to select Communicator Format.

    • Keypad will display [Feat. 6 Seg# 1].
    • Input 1 and *
    • Keypad will display [Enter the feature no., then #]
    • Note: Clear settingvalue for all other Telephone Number features

    Press 12 then # to select Download Access Code

    • Keypad will display [Feat. 12 Seg# 1].
    • Make a record of or input the download access code that must match what is entered or stored in the DL900 configuration (UDL) program.
    • Keypad will display [Enter the feature no., then #]

    Press 13 then # to select Number of Rings/Number of Calls to Answer

    • Keypad will display [Feat. 13 Seg# 1].
    • Input 1 and * then 0 and *
    • Keypad will display [Enter the feature no., then #]

    Press 14 then # to select Download Control.

    • Keypad will display [Feat. 14 Seg# 1].
    • Input 1 to 8 so that no numbers are displayed and only '_' are shown. Press #
    • Keypad will display [Enter the feature no., then #]