Panel Connection – MCM

Manufacturer Vanderbilt
Model SPC 4300
Version MCM version greater or equal to V1.06
Minimum Panel Firmware V2.1.0
Cable required? MCM
Panel Profile Vanderbilt-SPC-MC
Panel Bus Connection None
Technical Notes

See below


Panel Connection Information

DualCom Pro MCM Vanderbilt (PC137421 MCM Unit)
A A
B B

Panel Programming

  • Default Keypad Login code = 1111
  • Login to panel > “Full Engineer” will be displayed > Press “Select” button > “System Status” will
    be displayed
  • Scroll down menu until “Communication” is displayed > Press “Select” button
  • Scroll down menu until “Modems” is displayed and press “Select” button > “Primary” is
    displayed > Press “Select” button
  • “Enable Modem” is displayed > Press “Select” button to set modem to be enabled
  • Scroll down menu until “Country Code” is displayed > Press “Select” button to set to UK
  • Scroll down menu until “Answer Mode” is displayed >Press “Select” button to set to numbered
    rings of 1 ring
  • Scroll down menu until “Line Monitoring” is displayed > Press “Select” button to set mode to
    “Disabled”
  • Press “Back” button until “Primary” is displayed > Scroll down menu until “Backup” is displayed
    > Press “Select” button to disable the backup modem
  • Press the “Back” button until “Modems” is displayed > Scroll down menu until “Central Station”
    is displayed > Press “Select” button
  • “Add” will be displayed > Press “Select” button to create a new “Central Station” account
  • Input account ID > Press “Enter” button. (Press and hold button for number input)
  • Input account name > Press “Enter” button > Select [SIA] as the protocol to use > Press “Select”
    button
  • Input the 1st “Phone Number” > Press “Enter” button > Clear 2nd “Phone Number” and press
    “Enter” button
  • Press ”Back” button until “Central Station” is displayed
  • Scroll down menu until “Remote Maint.” is displayed > Press “Select” button to enable “Remote
    Maintenance”
  • Scroll down menu until “ID” is displayed > Press “Select” button > Input ID
  • Scroll down menu until “Password” is displayed > Press “Select” button > Input password
  • Scroll down menu until “In Conns. Setts” is displayed > Press “Select” button > Disable IP
  • Press back until “Remote Maint” is displayed > Scroll down menu until “SPC Pro” is displayed >
    Press ”Select” button
  • Enable access, and input ID and passwords > Disable IP > Press “Back” until no longer in
    “Engineer Mode”