Panel Connection – TTL

Panel Connection Information

Panel Programming

• Enter Engineering Mode > Press Menu
• Select?UDL/Digi Options
• Select Digi Options
• Ensure the first and last option are set to E****A
• Select UDL Options
• Select UDL password (Enter required password) 1234 as default
• Select Area Accounts A,B,C,D Should be Blank
• Press Menu to go back to UDL/Digi Options
• Select?Program Digi
• Set Arc 1 Protocol to SIA level II
• Enter into ARC 1
• Primary and Secondary Number should be blank
• Set ‘Account Number’ as the Chip number (provided by the ARC)
• Dialling Attempts set to 2
• Reporting Areas set as required
• Reports as required (Final option should be set to ‘R’ to enable restores. If set to * you will see no restores)
• Set Config or Config 1 as ******IT (I=Connect via IP and T=Send SIA Text)
• Set Config 2 (if available) to 1** to use com port 1
• Press Menu to go back to UDL/Digi Options
• Select?Com Port Setup
• Select Com Port 1, set this to Emizon/WebWayOne
• Press Menu to go back to UDL/Digi Options
• Select?Setup Modules Menu
• Select Setup IP Data
• Yes to select:- Com port 1
• Set ComIP Address: 127.0.0.1
• Set ComIP Port: 50561
• Set ComIP Gateway: 127.0.0.1
• Set ComIP Subnet Mask: 255.255.255.000
• Polling / SMG leave blank
• Set Name/SMG Port 50561
• Log Out of Engineer Mode
• Restart Panel and DigiAir/DualCom Pro to establish the electrical connection

Troubleshooting

• “ATS path fail com 1” refers to a communication path issue. This can be disabled via Global Options > Hardware > Turn off ‘ATS Path faults' , also select Areas > Options > ATS Path Faults - deselect all areas and finally under Com Port Set up > On board digi needs to be set to ‘nothing fitted'.
• Panel Vr 2.09 has Com Port Issues This will not integrate this is fixed in Firmware Vr 2.09.01
• Panel version V3.0x requires Com Port 1 enabled in Protocol Options.
• Under ‘Program Digi' Menu > Config 2 > Set to use com port 1
• If only Com port 2 is available: Make sure the baud rate (modem speed) is set to 19200.
• For UDL on V3.0x panels Wintex 6.2 (Build 2.11) is required.
• Do not use any special characters within Area or Zone descriptions, this causes SIA alarm events to corrupt.
• Lost/Recovery Issue - Go to Program Digi > Config 1 and make sure A is not set i.e. A*****IT. It should be just ******IT.
• If No Alarms are seen - Go to the UDL/Digi Options > Setup Modules menu > Modem speed and make sure it is set to 19200.
• Only the alarm format SIA is supported.

Technical Notes

Line fault is through the serial interface, no extra settings are required in either the panel or the DigiAir/DualCom Pro