Panel Connection – Serial connection via ATS7090 board

Manufacturer Carrier
Model ATS
Version Advanced
Minimum DualCom Pro Firmware DualCom Pro: V2.33
Minimum Panel Firmware All versions greater and equal to 026.026.0141-0143
Cable required?
  • Ribbon cable (05-5042) (included with ATS7090)
  • ATS7090 - Peripheral
  • ATS7090 versions less or equal to V1.02 - please use SPT less or equal to V2.06
  • ATS7090 versions greater or equal to V1.03 - please use SPT greater or equal to V2.07
Panel Profile ARITECH-ADVANCED-ATS7090
Technical Notes When configuring the panel with a laptop, disconnect the ribbon cable between the Panel and DC Pro before connecting the Laptop. When finished, you must disconnect the laptop and then reconnect the ribbon cable. ATS7090 Peripheral MUST be situated on AUX3.

Panel Programming

  • Enter ‘Dialler’ menu [9]
  • Enter ‘CS 1’ menu [1]
  • Enter ‘Transm Path’ menu [2]
  • Select Option [‘TDA75XX’]
  • Enter ‘Protocol’ menu [3]
  • Select option [‘(X)SIA’]
  • Enter ‘Accounts’ menu
  • Select ‘Area N’ with [account numbers]
  • Enter [Mode] menu
  • Select option ‘Primary [CS]
  • Enter ‘Protocol Opt’ menu [8]
  • Enter [(X)SIA] menu
  • Set ‘Area Modifier' to [ON]
  • Set ‘Name Chars’ to [30]
  • Set ‘Event Number’ to [3 digits]
  • Set ‘Subev Codeing [to ‘Decimal]
  • Set [SIA Frequency] to [Bell]
  • Go back to [Dialler] menu level
  • Enter ‘Path Options’ menu [3]
  • Enter ‘Path Options’ menu [3]
  • Enter ‘PSTN’ menu [1]
  • Enter ‘Line Fault’ menu and select option [No]
  • Go back to ‘Path Options’ menu level.
  • Enter ‘IP’ menu [4] If present
  • Enter ‘Line Fault’ menu and select option [No]
  • Go back to 'Path options' menu level
  • Exit Installer (Engineer) mode
  • Enter 'TDA75XX' menu [7]
  • Enter 'Line Fault' menu and select option 'If used'
  • Go Back to Installer Menu level and select Menu 8: Sys Opt > 7: Panel & AB Opts > 9: Remote Config - YES
  • Exit Installer (Engineer) mode

Technical Notes

  • May require full panel and DC Pro power cycle
  • User Code: Menu 8:2:1 - Need Acc [YES]
  • The Area Account in the Alarm Events. This might need to be adjusted in the Panel's Settings in order to have a specific Area Number not a generic Account Number [Example: Area 1 - 0001, Area 2 - 0002, etc.....]