Panel Connection – ATS7090
| Manufacturer | Aritech |
| Model | ATS Advisor Master |
| Minimum DualCom Pro Firmware | 04.11.08 (PD6662:2010) 04.09.24 (Non- PD6662:2010) |
| Panel Profile | ARITECH-ADVISOR-ATS7090 |
| Technical Notes |
When configuring the panel with a laptop, you first need to disconnect the ribbon cable between the Panel and DualCom Pro module before connecting the laptop. When finished, you must disconnect the laptop and then reconnect the ribbon cable before any alarms are sent from the panel to the DualCom Pro. LAPTOPS MUST NOT BE CONNECTED TO THE ALARM PANEL - This will STOP signals being sent to the DualCom Pro. |
IMPORTANT - The ribbon cable should be connected to the connector next to the RS232 terminals with the jumper on two pins farthest to the ribbon cable.
Panel Connection Information
| RS232-T | ATS7090 R |
| RS232-R | ATS7090 T |
| RTN | ATS7090 RET |
Panel Programming
Menu 9 – Communications Menu
- PBX [not set]
- MSN [not set]
- DT Detection [UK]
- DTMF tone dialling [Yes]
- Enable PSTN line fault monitor [No]
- Monitor service tones [No]
- 3 digit SIA extensions [Yes]
- ISDN point to point [No]
- Enable ISDN line fault monitor [No]
- 200 baud reverse area open/close [No]
- X25 TEI value [2]
- Audio listen in time [180]
- Audio listen in frame time [30]
- Report mains fault [Yes]
- Report line fault [Yes]
- Enable GSM line fault monitor [No]
- Central station
- CS No: [1] Enter
- Format No: X25 Enai /// number 12
- Ph1: [any number 11 digits]
- Ph2: [not set]
- Acc No: [account number] system. Advice: put 0001
- Acc No: [account number] area 1. Advice: put 0001
- Bell modem [No]
- Dual reporting [No]
- Listen in [No]
- Disable reporting inhibits [No]
- Reserved [No]
- XSIA Max characters [30]
- X25 account code [account number] . Panel account number (Chip ID)
- X25 line type [0]
- Conn type [ISDN-D]
- Suppress FTC for voice reporting [No]
- Retry count [10]
- SIA Area Modifier [Yes]
- X25 D-bit [Yes]
- Mains Fail Reporting delay [30]
- Enable IP Line Fault Monitor [No]
- AWDGP reporting codes for IMQ [No]
- Now Reboot ATS Panel & DualCom Pro
Technical Notes
- Menu 29 – Computer Connection menu
- Enable Remote UpDownload: Yes
- Up/Download if any area armed: Yes
- Enable Remote control: Yes or No
- Remote Control if any area armed: Yes or No
- Use modem Init: No
- Report Alarms to computer: No
- Report Access to computer: No
- Cmp: Empty
- Cbk: Empty
- Srv: Empty
- Computer Address: 0001
- Security Password: 0000000000
- Security Attempts: 255
- Number of Rings: 1
- Number of Calls: 0
- Answer Machine: No
- Reserved: No
- Bell Modem: No
- Conn Type: GSM
- PC connection authorised: No